Follow

Bed Installation

For this step, you may need:

  • 4mm hex key (for M5 SHCS bolts)

The aluminum bed assembly arrives completed and roughly leveled. Simply place the bed assembly into the corner bracket holes of the bed support assembly inside the printer. 

 

Reach underneath and behind the bed to connect the bed power and thermistor connectors. 

The glass build plate is prevented from shifting by the stop blocks on the aluminum bed assembly. Place the glass on the surface, push against the stop blocks, and lock into place by pushing the front and left stop blocks against the glass and tightening the thumbscrew/wingnut underneath. 

Your AON is ready to go! Proceed to software setup.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

0 Comments

Article is closed for comments.